Excavation

Leaking Pond Repair in Northern California

November 16, 2026

Leaking pond repair in Northern California usually comes down to one of three fixes: recompacting the bottom with the right equipment, blending in bentonite or imported clay, or repairing a leak at the outlet pipe or dam. The fix depends on where the water is going and what your soil is made of, so you find the leak first and pick the method second. If your stock pond drops more than evaporation can explain, the work is best done while the pond is low and dry, which in Tehama, Butte and Shasta counties means late summer through fall, before the rains fill it back up.

Picture a ranch between Corning and Red Bluff. The pond was fine for years, then one August it's half empty and the cattle are walking out into mud to drink. Sometimes it's a leak. Sometimes it's just a hot valley summer. You want to know which before anyone brings a dozer.

Is it a leak or just evaporation?

Every earthen pond loses water. Penn State Extension's guide to fixing a leaking pond says even a well-built pond on good soil can lose about an inch a month to seepage. A warm, breezy, dry day can take over a quarter inch to evaporation by itself. Their rule of thumb is that evaporation plus loss to trees rarely tops 12 inches in the driest month, and that a bigger drop points to a leak.

That guide is written for Pennsylvania. Our summers are hotter and drier, so expect more evaporation here than those numbers suggest. That's why we like a side-by-side test better than a rule of thumb.

The bucket test works. Set a 5-gallon bucket on a step or a block in the shallow edge of the pond, fill it to the same level as the pond, and mark both lines. Wait a week with no rain. If the pond dropped a lot more than the bucket, the extra is going somewhere other than the sky.

A few other clues help narrow it down:

  1. Wet ground, cattails or a green strip on the downstream face or toe of the dam
  2. Water that drops fast and then holds steady at one level, which usually means the leak sits at that height
  3. A rusted or cracked outlet pipe, or a soft wet spot right where the pipe exits the dam
  4. Ground squirrel or gopher holes in the bank near the waterline

That third one is the first place we look on older ponds. Steel outlet pipes rust through, and water follows the outside of a pipe that was never compacted well. If the leak is at the pipe, sealing the whole bottom won't help.

Which fix fits your pond?

Once you know where the water's going, the soil decides the method. Here's how the common options compare.

MethodWhat it isWorks best whenWatch out for
RecompactionDrain or wait for low water, scarify the bottom about 12 to 16 inches deep, then compact it back in layers at the right moistureThe native soil has a decent mix of fine and coarse materialSoil that's too sandy or gravelly won't seal no matter how many passes you make
BentoniteSpread bentonite clay at about one pound per square foot, mix it into the top 3 to 4 inches, then compactCoarse soil with low clay contentIt has to stay wet. If the pond dries out and the bentonite cracks, it can leak again
Imported clay blanketHaul in clay, Penn State says at least 20 percent clay, and place a compacted layer at least 6 inches thick, preferably a footNo usable clay on site and leaks spread across the bottomYou need a good clay source nearby, and trucking adds up fast
Synthetic linerLay a plastic liner and cover it with at least 9 inches of soilSmall ponds, or soil nothing else will sealUsually the most expensive way to do it, and cattle hooves and burrowing animals can tear it
Outlet or dam repairDig out and replace the pipe, recompact around it, rebuild the damaged section of the damThe leak traces to the pipe or one section of embankmentCan trigger permits on larger dams (see below)

Our opinion: try to find and fix a specific leak before you treat the whole bottom. Spot repairs cost a fraction of resealing an acre. If you can't find the leak and the pond loses water evenly, then you're looking at a full-bottom job, and that's when the soil test matters.

Why compaction fails on some valley ponds

A lot of the ground around Corning and Los Molinos holds water well. The gravelly benches and old creek terraces don't. A pond dug into cobble was never going to hold water without imported clay or bentonite, and no amount of rolling will change that. If your pond was dug into gravel, skip straight to the clay conversation.

The other way compaction fails is moisture. Clay compacted too dry won't seal, and clay that dries and cracks after the job will leak again. That's one reason we don't love doing this work in the middle of July.

Why fall is the window

The best time to fix a leaking pond here is when it's at its lowest and the bottom has dried enough to carry equipment. For most stock ponds in the Sacramento Valley foothills, that's September into November.

It's mid-November now. If your pond is still low and the bottom is firm, there may be time to get it done before steady rain sets in. If the first storms already put a foot of water back in it, we'd usually wait. Pumping a pond down in December to fight a muddy bottom costs more and turns out worse than doing it right next September. Use the winter to watch it. Mark the level after it fills and note where it stops dropping in spring. That gives whoever does the repair a head start.

Permits to check before anyone digs

Most small stock pond repairs are simple on paper, but a few rules catch people.

Dam size

The state Division of Safety of Dams takes jurisdiction over a dam that's more than 6 feet high and holds 50 acre-feet or more, or one that's 25 feet or higher and holds more than 15 acre-feet. Most ranch ponds fall under that line, but check the DWR jurisdictional size page if yours is large. Work on a jurisdictional dam needs state approval first.

On-stream ponds

If your pond sits on a creek or a seasonal drainage, the California Department of Fish and Wildlife may require a Lake or Streambed Alteration notification before you dig in or around it. Ponds dug off-stream, fed by a well or a ditch, usually avoid this. If you're not sure which you have, ask before the work starts.

County grading

Bigger jobs that import or move a lot of material can bump into county grading rules. Your county building or public works department can tell you where the line is for your parcel.

None of this should scare you off a repair. It just means the first conversation should cover where the pond sits and how big the dam is.

What it costs

We won't put a number on your pond without seeing it, because the spread is huge. Fixing a rusted outlet pipe and recompacting around it is a small job. Resealing the bottom of a one-acre pond with imported clay is a big one, and hauling distance alone can swing the price. The things that move the bill most are how much water has to come out, whether the leak can be found, what your soil is, and where the clay or bentonite comes from.

If you want a real number, request a free estimate and tell us what you're seeing at the pond, the dam and the outlet.

Common Questions

How do I know if my pond is leaking or just evaporating?

Run a bucket test. Set a bucket of pond water in the shallow edge so it gets the same sun and wind, mark both levels, and compare after a week without rain. If the pond drops a lot more than the bucket, you have a leak or heavy seepage.

Can you fix a pond leak without draining it?

Sometimes. A leak near the surface along the bank or around a burrow can often be dug out and packed with clay once the water drops below it. A leak at the bottom or around a deep outlet pipe usually means pumping the pond down or waiting until it's dry.

Is bentonite or compaction better for sealing a pond?

Compaction is the cheaper choice and works when your native soil has enough fine material in it. Bentonite is for coarse, sandy or gravelly soil that won't seal on its own. Both need good compaction, and both have to stay wet afterward to keep working.

Do I need a permit to repair a stock pond in California?

Many small off-stream stock ponds don't need a state permit for a repair. Ponds on a creek or drainage may need a CDFW Lake or Streambed Alteration notification, and larger dams can fall under the Division of Safety of Dams. Check both before you start.

When is the best time to fix a leaking pond in Northern California?

Late summer through fall, when the water is lowest and the bottom is dry enough to carry equipment. Once the winter rains refill it, most repairs are better pushed to the next dry season.

Bottom line

Don't reseal a whole pond until you know where the water's going. Check the outlet pipe and the dam face first, and run a bucket test before you pay for a single load of clay. If the pond is still low and dry this month, there's a short window left. If it's already filling, mark the levels this winter and plan the repair for next fall.

Walberg, Inc. has been doing excavation work across the north state since 1999, and we run our own equipment for pond work and excavation. If the pond is silted in as well as leaking, our post on ranch pond cleaning covers how the two jobs fit together. We work all over Tehama County and the rest of the north valley. When you're ready, request a free estimate and we'll take it from there.

Need an estimate? We'll be on-site this week.